How to Kit a Pro Tech Base Toolkit

This guide demonstrates how to prepare the kitting process for the Pro Tech Base Toolkit, as well as what steps to take to create 1 kit.

  • Author: iRobot
  • Time required: 1 minute and 57 seconds
  • Difficulty: Easy
Relevant Parts
Relevant Parts (continued)
Image #1

Add Note Step 1 — How to Kit a Pro Tech Base Toolkit  ¶ 

  • Set up the tools in a rainbow formation in order from right to left.

  • Place the opened, empty pouch in the middle of your workstation.

    • Place the box of pouches to the lower right side of the table.

    • Place a trash can on the lower left side of the table.

Image #1 Image #2

Add Note Step 2  ¶ 

  • Holding onto the end of the packaging, shake the 4 metal spudgers out.

    • Be careful, don't shake too hard or the tools will go flying.

  • Insert each spudger into an individual slot.

    • Make sure the spudger with the sharp end has the sharp end facing out.

  • Throw the packaging away.

Image #1

Add Note Step 3  ¶ 

  • Place the black spudger in the same slot as the smallest metal spudger, as shown.

Next » « Previous

Comments Add Note Comments are offturn on