Arduino Power Cable
  • Arduino Power Cable

  • 220V Bridge Cable

  • 220V Power Cable

Add Comment

Phillips Screw Driver
  • Phillips Screw Driver

Add Comment

Connect the 220V Power Cable and the 220V Bridge Cable to the 100W Power Supply as shown in the picture The Brown cable goes to L, the Blue cable goes to N and the Yellow and Green cable goes to Ground.
  • Connect the 220V Power Cable and the 220V Bridge Cable to the 100W Power Supply as shown in the picture

  • The Brown cable goes to L, the Blue cable goes to N and the Yellow and Green cable goes to Ground.

  • Connect the other end of the 220V Bridge Cable to the L, N and Ground ports of the 400W Power Supply as shown

  • Make sure all the screws holding the cables are tightened with the phillips screw driver

Add Comment

Connect the Arduino Power Cable to the 100W Power Supply
  • Connect the Arduino Power Cable to the 100W Power Supply

  • The red cable connects to V+ and the Black cable connects to COM

  • Connect the other end to the power connector on the CNC shield. The Red Cable is + and the Black Cable is -.

Add Comment

Finish Line

2 other people completed this guide.

Paul Cronje

Member since: 09/03/2017

821 Reputation

26 Guides authored

0 Comments

Add Comment