Spindle Speed Controller
  • Spindle Speed Controller

  • Relay COM Cable

  • Relay 12V Cable

  • Relay Signal Cable (with 2 pin connector)

  • M4 Lock Nuts (2 Pcs)

  • M4x8 Cap Screw (2 Pcs)

Add Comment

3mm Allen Key
  • 3mm Allen Key

  • Small Phillips Screw Driver

  • Phillips Screw Driver

  • Sharp Nose Pliers

Add Comment

Mount the Spindle Speed Controller as shown with the M4x8 Cap Screws (2 Pcs) and the M4 Lock Nuts (2 Pcs)
  • Mount the Spindle Speed Controller as shown with the M4x8 Cap Screws (2 Pcs) and the M4 Lock Nuts (2 Pcs)

  • Tighten the screws with the 3mm Allen Key and the Sharp nose pliers

Add Comment

Connect the black cable of the Speed Controller to the V- port on the 400W power supply Connect the Red cable of the speed controller to the NO port on the Relay
  • Connect the black cable of the Speed Controller to the V- port on the 400W power supply

  • Connect the Red cable of the speed controller to the NO port on the Relay

  • Connect the Relay COM cable to the V+ port on the 400W power supply and to the COM port on the relay

Add Comment

Connect the Relay Signal cable to the IN port on the relay (red cable) and to the DC- port on the relay (black cable) Plug the 2 pin connector to the Z+ pins on the CNC shield with the red cable closest to the stepper drivers as shown Plug the 2 pin connector to the Z+ pins on the CNC shield with the red cable closest to the stepper drivers as shown
  • Connect the Relay Signal cable to the IN port on the relay (red cable) and to the DC- port on the relay (black cable)

  • Plug the 2 pin connector to the Z+ pins on the CNC shield with the red cable closest to the stepper drivers as shown

Add Comment

Connect the Relay Power Cable to the DC+ port on the Relay and to the +V port on the 100W Power supply
  • Connect the Relay Power Cable to the DC+ port on the Relay and to the +V port on the 100W Power supply

Add Comment

Finish Line

2 other people completed this guide.

Paul Cronje

Member since: 09/03/2017

821 Reputation

26 Guides authored

0 Comments

Add Comment